$999.00 – Sold Out
The LT5800 5760W 2 Channel PFC Power Amplifier is a lightweight power amp which provides maximum headroom with pure amplification of the original signal source to extreme levels, covering all frequencies without added color. The LT5800 is designed for the largest events with multiple subs, and features a single space 1U frame, is 2 ohms capable, and includes PFC Power Factor Correction, which is internationally recognized as the foremost self-regulating power supply for high-end amplifiers. The LT5800 has exceptional headroom with lower power requirements than amps with a traditional power supply. Other models available in the LT Series are the LT2000 2010W 2 Channel PFC Power Amplifier, and the LT5204 4 Channel 5150W PFC Power Amplifier.
The LT5800 2ch model delivers 1010W RMS at 8 ohms, 1690W at 4 ohms and 2880W at 2 ohms from each channel (5760W 4 ohms bridged).
» Power: 1010 WRMS @ 8ohms, 1690W @ 4ohms, 2880W @ 2ohms, 5760W Bridged @ 4ohms
» Active PFC Power Factor Correction
» Space saving lightweight 1-U frames
» High slew rate class D design
» Natural, pure-state amplification
» 2 ohm operation, 4 ohm bridged design
» For 70V/100V distribution systems
» Soft-Start 100-240VAC 50-60Hz
» PowerCON™ AC connector
» Front to rear cooling system
» Protect and Limiter circuits
» IEC60065 compliant, CB certified
» Up to 12 LT amplifiers in one 12U rack case
» 1 Year Warranty
PFC Power Factor Correction corrects the incoming AC power by synchronizing the AC voltage to the line current to reduce energy consumption and heat, which produces substantially more power from the same AC input.
Twist-Lock connectors are featured for high power applications. Secure the Twist-Lock cable connection by turning to the right to the lock position. Twist-Lock outputs are compatible with standard 2-conductor Twist-Lock cables. A 4 conductor Twist-Lock cable will enable bi-amping with one 4 conductor cable.
The PROTECT circuit will engage when the output load draws excessive current or a direct short is detected caused by a shorted speaker cable or speaker system. Thermal protection is also included in the PROTECT circuit. The LIMITER is designed to protect against distortion by automatically reducing the signal to prevent hard clipping, which helps protect the drivers. This feature can be turned off if desired.